1. IDLE MIXTURE SCREW : ( Air Fuel ratio , A/F ) ( ON ALL MODELS )
To adjust the IDLE MIXTURE SCREW use a screw driver and turn it clockwise and counterclockwise until you get the highest
RPM possible ! , after that press the gas to 3000 RPM to richen the Air Fuel mixture .
2. STOP THROTTLE SCREW SCREW : ( a screw with a plastic head )( all models)
This screw is just located above the hole of the IDLE MIXTURE SCREW see pictures below
PROCEDURE # 1 ( if you have the IDLE CONTROL SCREW in # 3 ) :
adjust the STOP THROTTLE SCREW by hand to the lowest idle possible ( counterclockwise )PROCEDURE # 2 ( if you DON'T have the IDLE CONTROL SCREW in # 3 ) :
adjust the STOP THROTTLE SCREW by hand to the desired RPM ( 750 > 800 RPM )3. IDLE CONTROL SCREW : ( NOT ON ALL MODELS ) ( I don't have it )
After adjusting the STOP THROTTLE SCREW to the lowest idle possible in PROCEDURE # 1 adjust this screw using a screwdriver to the desired RPM ( 750 > 800 RPM )This IDLE CONTROL SCREW is located on the throttle bracket after the throttle adjustment nut , it should be in the marked area ( but as you can see i don't have it )
4. FAST IDLE SCREW : ( ON ALL MODELS ) ( Works in the cold morning )
This screw adjusts the RPM that car should rev at in cold mornings it should be from 2000 > 3000 this screw is really hard to find and reach , i just found it today !!! here is the area that it should be i !you can adjust it by a screwdriver but you can only test it in the mornings ( don't mess with it if it is , r r cleaner to get better response in the mornings )
5. A/C IDLE SCREW : ( ON MODELS EQUIPPED WITH A/C ) ( Works in w hen A/C ON )
This screw adjusts the RPM when the A/C is on !just adjust with a screwdriver , clockwise to increase RPM and counterclockwise to decrease !
i think the normal RPM is 1250 > 1500 RPM ( correct me if i am wrong )
