How to do a rear camber washer trick!
Well, I got this free with my Omnipower front camber kit… so this is how you install it
jack up car
remove wheel
… take a smoke break
then you’ll be looking at this
Take your 14 mm and a couple of extensions and bust those bad boys loose.
Take 2 washers per bolt and slide them between the body and the upper rear control arm. Install longer bolts as provided in the kit. Torque them to 29 lb-ft
replace the wheel, and torque the wheel to ~80 lb-ft.
Repeat for the other side.
You are done. No more bunk camber.
Oh wait… one more step. Go to the front on ONE side… raise the car up as high as you safely can. Now check the rear opposite side, the wheel should have tucked into the wheelwell. By flexing the susp, you should make sure your newly corrected camber doesn’t cause an issue with your wheelwell.
